Toro Z Master 4000 Series, Руководство по обслуживанию, Страница: 101 / 114

Left and Right Neutral Switch Removal (continued)
3. Remove the 4 (1/4-20 inch) torx screws securing the side pod to the console.
Remove the side pod from the console.
4. Push on the 2 tabs on either side of the neutral switch and push the switch
through the mount hole to remove.
Left and Right Neutral Switch Installation
1. Install the neutral switch to the mount hole on the machine.
2. Install the side pod onto the console. Install the 4 (1/4-20 inch) torx screws
securing the side pod to the console.
3. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
Left and Right Neutral Switch Test
The neutral switch is a single pole plunger type switch (normally open) with
two terminals. When the plunger is depressed, the circuit closes and there is
continuity between the terminals.
Motion control levers in neutral position (OUT), the switch will have continuity
(closed).
Motion control levers in the operating position (IN), the switch will NOT have
continuity (open).
g336403
Figure 84
Park Brake Switch Replacement
Park Brake Switch Removal
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop and remove the key. Engage the
parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Remove the 2 (5/16 inch) screws securing the park brake switch bracket to
the chassis.
4. Pull the park brake switch bracket away from the chassis and unplug.
5. Remove the park brake switch from the park brake switch bracket.
4000 Series Z MASTER® Service Manual Page 8–7 Electrical: Service and Repairs
3442-427 Rev A