Controls System
Maintenance
Adjusting the Accelerator
Pedal
1. Position the vehicle on a level surface, stop the
engine, and engage the parking brake.
2. Adjust the ball joint on the accelerator cable
(Figure 71) to allow 0.100 to 0.250 inch (2.54 to
6.35 mm) of clearance between the accelerator pedal
arm and the top of the diamond tread floor plate
(Figure 72), when a 25 lb (11.3 kg) force is applied to
the center of the pedal. Tighten the locknut.
Note:
The engine must not be running and the
return spring must be attached.
Figure 71
1.
Accelerator cable
2.
Ball joint
Figure 72
1.
0.100 to 0.250 inch (2.54 to 6.35 mm) clearance
Important:
The maximum high idle speed is 3650
rpm. The high idle stop should not be adjusted.
Adjusting the Clutch Pedal
Service Interval:
Every 200 hours
Note:
You can adjust the clutch pedal cable at the bell
housing or at the clutch pedal pivot. The front hood can
be removed to ease the access to pedal pivot.
1. Loosen the jam nuts securing the clutch cable to the
bracket on the bell housing (Figure 73).
Figure 73
1.
Clutch cable
3.
Return spring
2.
Jam nuts
4.
Ball joint
Note:
You may remove and rotate the ball joint, if
additional adjustment is required.
2. Disconnect the return spring from the clutch lever.
3. Adjust the jam nuts or ball joint until the back, rear
edge of the clutch pedal is 3.75 ± 0.12 inch (9.5
± 0.3 cm) from the top of the floor plate diamond
pattern, when an 4 lb (1.8 kg) force is applied to the
pedal (Figure 74).
Figure 74
1.
Clutch pedal
2.
3.75 ± 0.12 inch (9.5 ± 0.3
cm)
Note:
Force is applied so the clutch release bearing
lightly contacts the pressure plate fingers.
4. Tighten the jam nuts after the adjustment has been
attained.
52
Содержание workman HDX-D 07368
Страница 41: ...Figure 44 Figure 45 41...
Страница 58: ...Schematics Hydraulic Schematic Rev B High Flow Hydraulics Schematic TC models only Rev A 58...
Страница 59: ...Electrical Schematic Rev D 59...
