Specifications
Note:
Specifications and design are subject to change
without notice.
Dimensions
Overall Width
63 inches (160 cm)
Overall Length
w/o bed: 128.25 inches (326 cm)
w/full bed: 130.38 inches (331 cm)
w/2/3 bed in rear mounting location:
136.38 inches (346 cm)
Base Weight (Dry)
Model 07368—1956 lb (887 kg)
Model 07368TC—2037 lb (924kg)
Model 07371—2015 lb (914 kg)
Model 07371TC—2096 lb (951 kg)
Rated Capacity
(includes 200 lb.
operator, 200 lb.
passenger and loaded
attachment).
Model 07368—2894 lb (1313 kg)
Model 07368TC—2813 lb (1276 kg)
Model 07371—2835 lb (1286 kg)
Model 07371TC—2754 lb (1249 kg)
Maximum. Gross
Vehicle Weight
4,850 lb (2200 kg)
Tow Capacity
Tongue weight 600 lb (272 kg)
Maximum trailer weight 3,500 lb (1587
kg)
Ground Clearance
7 inches (18 cm) w/ no load
Wheel Base
70 inches (118 cm)
Wheel Tread (center
line to center line)
Front: 46 inches (117 cm)
Rear: 47.7 inches (121 cm)
Height
75 inches (190.5 cm) to top of ROPS
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Before servicing or making adjustments to
the machine, stop the engine, set the parking
brake, and remove the key from the switch.
Remove any load material from the bed or
other attachment before working under a
raised bed. Never work under a raised bed
without positioning the safety support on a fully
extended cylinder rod.
Checking the Engine Oil Level
Service Interval:
Before each use or daily
The engine is shipped with approximately 3.5 quarts
(3.3 l) (w/ filter) of oil in the crankcase; however, you
should check the oil level before and after the engine
is first started.
Note:
The best time to check the engine oil is when
the engine is cool before it has been started for the
day. If it has already been run, allow the oil to drain
back down to the sump for at least 10 minutes before
checking. If the oil level is at or below the Add mark
on the dipstick, add oil to bring the oil level to the Full
mark.
Do not overfill.
If the oil level is between the
Full and Add marks, no additional oil is required.
The engine uses any high-quality 10W-30 detergent
oil having the American Petroleum Institute (API)
service classification CF or higher. Choose a viscosity
according to the table in Figure 14.
Figure 14
1. Position the machine on a level surface.
2. Remove the dipstick and wipe it with a clean rag.
Insert the dipstick into the tube and make sure it is
20
Содержание workman HDX-D 07368
Страница 41: ...Figure 44 Figure 45 41...
Страница 58: ...Schematics Hydraulic Schematic Rev B High Flow Hydraulics Schematic TC models only Rev A 58...
Страница 59: ...Electrical Schematic Rev D 59...