Toro workman HDX-D 07368, Руководство оператора

Страница: 13 / 60

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
Steering wheel 1
Cap 1
1
Washer 1
Install the steering wheel.
ROPS frame
1
2
Bolt, 1/2 inch 6
Mount the ROPS (Rollover Protection
System)
3
Electrolyte A/R Activate and charge the battery.
4
No parts required
–
Check the engine oil, transaxle/hydraulic
fluid, and brake fluid levels
Media and Additional Parts
Description Qty. Use
Operator’s Manual 1 Read before operating the vehicle
Parts Manual 1 Use to reference part numbers
Operator Training Material 1 View before operating machine
Note:
Determine the left and right side of the machine
from the normal operating position.
1
Install the Steering Wheel
(TC Models Only)
Parts needed for this procedure:
1 Steering wheel
1 Cap
1 Washer
Procedure
1. Remove the nut from the steering shaft. Slide the
steering wheel, and washer onto the steering shaft
(Figure 3).
2. Secure the steering wheel to the shaft with the nut
and tighten it to 20-25 ft-lb (27–34 N-m).
3. Install the cap on the steering wheel.
Figure 3
1. Steering wheel 3. Cap
2. Jam nut 4. Washer
13