2
Install ROPS
(TC Models Only)
Parts needed for this procedure:
1
ROPS frame
6
Bolt, 1/2 inch
Procedure
1. Align each side of the ROPS with the mounting
holes on each side of the vehicle frame as shown in
Figure 4.
2. Secure each side of the ROPS to frame with 3 bolts
(1/2 inch) and tighten then to 85 ft-lb (115 N-m).
Figure 4
1.
ROPS
3.
ROPS cover plate
2.
Mounting bracket
3
Activate and Charge the
Battery
(TC Models Only)
Parts needed for this procedure:
A/R
Electrolyte
Procedure
If the battery is not filled with electrolyte or activated, it
must be removed from the vehicle, filled with electrolyte
and charged. Bulk electrolyte with 1.260 specific gravity
can be purchased from a local battery supply outlet.
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Battery electrolyte contains sulfuric acid which
is a deadly poison and causes severe burns.
•
Do not drink electrolyte and avoid contact
with skin, eyes or clothing. Wear safety
glasses to shield your eyes and rubber gloves
to protect your hands.
•
Fill the battery where clean water is always
available for flushing the skin.
1. Remove the battery cover from the battery case
(Figure 5).
14
Содержание workman HDX-D 07368
Страница 41: ...Figure 44 Figure 45 41...
Страница 58: ...Schematics Hydraulic Schematic Rev B High Flow Hydraulics Schematic TC models only Rev A 58...
Страница 59: ...Electrical Schematic Rev D 59...
