Toro reelmaster 216, Руководство оператора

Страница: 23 / 36

LUBRICATION
GREASING BEARINGS AND BUSHINGS
(Fig. 23–31)
The traction unit and cutting unit’s grease fittings must
be lubricated regularly with No. 2 General Purpose
Lithium Base Grease. If the machine is operated under
normal conditions, lubricate bearings and bushings after
every 25 hours of operation. Bearings and bushings
must be lubricated daily when operating conditions are
extremely dusty and dirty. Dusty and dirty operating
conditions could cause dirt to get into the bearings and
bushings, resulting in accelerated wear.
The traction unit bearings and bushings that must be
lubricated are:
Steering column (Fig. 23), steering gears (2) (Under
skirt below steering sector) steering shaft (2) (Fig. 24),
jackshaft pulley bearing (2) (Fig. 25), lift arms (3) (Fig.
26) pivot rods (3) (Fig. 27), and belt tensioners (3) (Fig.
28).
Also, apply grease to slots in cylinder support (Fig. 29).
The cutting unit lubrication points are: Single point
adjustment knob (2) (Fig. 30), reel flange bearing (2)
and front and rear rollers (Fig. 31).
Figure 23
Figure 24
Figure 25
Figure 26
Figure 27
23
Maintenance