Toro reelmaster 216, Руководство оператора

Страница: 33 / 36

INSTALL COUNTERBALANCE
SPRINGS
1. Hook one end of the spring into the second hole
(from bottom) on the cutting unit lift tab (Fig. 49).
2. On the front cutting units secure other end of the
spring to the appropriate hole (see chart) on the
counterbalance arm with the spring shackle, (2) cle-
vis pins and (2) cotter pin.
Note: On the rear counterbalance spring, install a
vinyl cover over the spring before installing.
3. On the rear cutting unit, secure the other end of the
spring to the appropriate hole (see chart) in the
counterbalance arm with (2) chain links (5-, 8- &
11-blade floating cutting units) or (3) chain links
(5-blade fixed cutting units) spring shackle (2) cle-
vis pins and (2) cotter pins.
A. Second hole from Bottom—for 5-blade reel
application
B. Middle hole—for 8-blade reels without baskets
C. Top hole—for 8 blade reels using baskets
IMPORTANT: These are recommended settings.
Readjust the spring positions to attain optimum per-
formance. By raising the spring locations on the
counterbalance arms, the cutting unit weight on the
ground is reduced and traction is increased.
4. To tension the counterbalance springs proceed as
follows:
A. Remove the cotter pin and clevis pin securing
the spring shackle to the counterbalance arm.
Do not remove the other clevis pin.
B. Move the shackle up or down on counterbal-
ance arm until aligned with the desired hole of
the arm. Reinstall the clevis pin and cotter
pin.
33
Cutting Unit
Figure 49
1. Cutting unit lift tab
Figure 50
1. Counterbalance arm
2. Spring shackle
3. Clevis pin & cotter pin
Figure 51
1. Rear counter balance spring
2. Chain links
3. Vinyl cover
4. Spring shackle