Toro reelmaster 216, Руководство оператора

Страница: 10 / 36

CHECK THE CRANKCASE OIL
The engine is shipped with oil in the crankcase; howev-
er, you must check the oil level before and after you first
start the engine.
1. Position the machine on a level surface.
2. Remove the dipstick and wipe it with a clean rag.
Push the dipstick down into the dipstick tube and
make sure it is seated fully. Pull out the dipstick
and check the oil level. If the level is low, add
enough oil to raise the level to the FULL mark on
the dipstick.
A. Above 0° C—Use SAE 30.
B. Below 0° C—Use SAE 5@-20 or 5W30.
IMPORTANT Check the oil level every 5 operat-
ing hours or daily. Change the oil after every 50
hours of operation.
FILL THE FUEL TANK
Diesel Model:
The engine runs on No. 2 diesel fuel. Fuel tank capacity
is 24.6 liters (6.5 gallons).
1. Clean the area around the fuel tank cap.
2. Remove the fuel tank cap.
3. Fill the tank to about 2.5 cm (one inch) below the
top of the tank (bottom of the filler neck). DO
NOT OVERFILL. Then install the cap.
4. To prevent a fire hazard, wipe up any fuel that may
have spilled .
10
Figure 1 Diesel Model
1. Dipstick
Figure 2 Gasoline Model
1. Oil fill cap
Figure 3
1. Oil fill cap
Before Operating
Before servicing or making adjustments to the
machine, stop the engine and remove the key
from the switch.
CAUTION