Toro reelmaster 216, Руководство оператора

Страница: 13 / 36

2. Make sure the machine has been operated so the oil
is warm. Check the oil level oil by looking in the
sight gauge. If the oil level is at the center of the
gauge, it is sufficient.
3. If the oil level is not at the center of the gauge,
remove the cap from the hydraulic oil reservoir and
slowly fill the reservoir with Mobil DTE 26 or
equivalent hydraulic oil until the level reaches the
center of the sight gauge. DO NOT OVERFILL.
IMPORTANT To prevent system contam-
ination, clean the top of the hydraulic oil
containers before puncturing. Make sure
the pour spout and funnel are clean.
4. Install the reservoir cap. Wipe up any oil that may
have spilled.
DIESEL MODELS: INSPECT
THE FUEL FILTER
Inspect the fuel filter bowl daily for water or other cont-
aminants. If water or other contaminants are present,
they must be removed before operation.
1. Close the fuel shut-off above the filter.
2. Unscrew the nut securing the bowl to the filter
head. Remove water or other contaminants from
the bowl.
3. Inspect the fuel filter and replace it if it is dirty.
4. Re-install the bowl to the filter head. Make sure to
position the O-ring correctly between the bowl
mounting nut and the filter head.
5. Open the fuel shut-off above the filter to re-fill with
fuel. Close the bleed screw.
6. Open the bleed screw on the filter mounting, allow-
ing the bowl to re-fill with fuel. Close the bleed
screw.
Figure 7
1. Hydraulic reservoir cap
2. Sight Gauge
13
Before Operating
Figure 8
1. Fuel filter
Because diesel fuel is flammable, use caution
when storing or handling lt.
• Do not smoke while filling the fuel tank.
• Do not fill the fuel tank while the engine
is running, hot, or when the machine is in
an enclosed area.
• Always fill the fuel tank outside and wipe
up any spilled diesel fuel before starting
the engine.
• Store fuel in a clean, safety-approved con-
tainer and keep the cap in place. Use
diesel fuel for the engine only; not for any
other purpose.
DANGER