Toro Power Plex 51880, Руководство оператора

Страница: 14 / 24

SUPERCEDED
Removing the Battery Pack
1. Place the chain saw on a flat surface.
2. Press down on the latch and remove the battery pack
from the cavity.
g192109
Figure 22
1. Latch
Charging the Battery Pack
Important:
Read all safety precautions.
Important:
For best results, charge your battery pack
in a location where the temperature is more than 0°C
(32°F) but less than 50°C (122°F). To reduce the risk
of serious personal injury, do not store it outside or in
vehicles. Charging time increases if you do not charge
it within this range.
Note:
At any time, press the battery-charge-indicator button
on the battery pack to display the current charge (LED
indicators).
1. Make sure that the vents on the battery pack are clear
of any dust and debris.
2. Line up the cavity in the battery pack ( Figure 23 ) with
the tongue on the charger.
g192748
Figure 23
1. Battery pack cavity 4. Battery-charge-indicator
button
2. Battery pack terminals 5. LED indicators (current
charge)
3. Battery pack venting areas
3. Make sure that the vents on the battery charger are
clear of any dust and debris.
4. Slide the battery pack into the charger until it is fully
seated (
Figure 24 ).
g194423
Figure 24
1. Charger venting areas 3. Right indicator light
2. Left indicator light
5. To remove the battery pack, slide the battery backward
out of the charger.
6. Refer to the following table to interpret the LED
indicators on the battery charger.
14