Toro Power Plex 51880, Руководство оператора

Страница: 18 / 24

SUPERCEDED
g192116
Figure 30
1. Oil passage 3. Spacer
2. Clip 4. Drive sprocket
6. Inspect the drive sprocket; if it is excessively worn or
damaged, replace it.
7. Check the oil passage ( Figure 30 ) for debris and clean
the area if necessary.
8. Install the drive sprocket, spacer, and clip.
9. Clean the guide bar and chain; use a wire or a small
flat-head screwdriver to remove dirt and debris from
the groove along the edge of the guide bar, starting
from the sprocket on the front end and moving
rearward.
If the guide bar or grooves are damaged or the sprocket
on the front end does not rotate freely, replace the
guide bar; if the chain is excessively worn or damaged,
replace it.
10. Place the chain around the drive sprocket on the front
end of the guide bar,
with the cutting edge of the
chain teeth on the top of the bar facing forward
as shown in the diagram on the side of the chain saw
(
Figure 31 C).
g192112
Figure 31
11. Feed the chain around the guide bar and align the chain
teeth into the groove of the bar.
12. Position the open loop of the chain (not on the guide
bar) around the drive sprocket on the chain saw and
install the guide bar and attached chain onto the chain
saw as shown in
Figure 31 .
Important:
Ensure that the chain adjusting stud
is inserted into the hole indicated by the arrow
in
Figure 31 C. You may need to rotate the chain
tensioning knob to fit the stud into the hole in the
guide bar.
13. Install the cover and the wing nut, but do not fully
tighten the wing nut (
Figure 31 D).
14. Adjust the chain tension; refer to Adjusting the Chain
Tension (page 17) .
Sharpening the Chain
Service Interval: Before each use or daily
Yearly or before storage
The chain needs sharpening or replacement when you must
force it onto the wood or it produces smaller chips than when
it was new.
18