Toro Power Plex 51880, Руководство оператора

Страница: 20 / 24

SUPERCEDED
Troubleshooting
Problem Possible Cause Corrective Action
1. The chain brake is engaged. 1. Disengage the chain brake by moving
the chain brake rearward.
2. The battery pack is low on charge.
2. Charge the battery pack.
3. The battery pack is not fully seated. 3. Ensure that the battery pack is inserted
all the way into the housing.
4. The battery pack is too hot. 4. Allow the battery pack to cool.
5. The battery pack has exceeded high
amperage limits.
5. Release the trigger, then press the
trigger switch.
The motor does not run or runs
intermittently.
6. There is debris under the cover. 6. Remove the cover and clean out any
debris.
The motor runs, but the chain does not
rotate. 1. The chain is not properly seated on the
drive sprocket.
1. Install the chain and ensure that the
links are properly seated in the drive
sprocket.
The chain brake does not engage. 1. There is a chain brake malfunction. 1. Immediately take the chain saw to a
local service location.
1. The chain is not tensioned correctly. 1. Set the proper tension on the chain.
2. The chain is dull. 2. Replace the chain.
3. The chain is installed backward. 3. Install the chain correctly.
The chain saw does not properly cut.
4. The chain is dry. 4. Check the oil level.
1. The oil port is plugged. 1. Clean out debris from the oil port. The chain oil is not lubricating properly.
2. The oil groove in the guide bar is
plugged.
2. Clean out debris in the bar.
The battery pack loses charge quickly. 1. The battery pack is over or under the
appropriate temperature range.
1. Move the battery pack to a place
where it is dry and the temperature is
between 0°C (32°F) and 50°C (122°F).
1. The battery charger is over or under
the appropriate temperature range.
1. Unplug the battery charger and move
it to a place where it is dry and the
temperature is between 0°C (32°F)
and 50°C (122°F).
The battery charger is not working.
2. The outlet that the battery charger is
plugged into does not have power.
2. Contact your licensed electrician to
repair the outlet.
1. There is moisture on the leads of the
battery pack.
1. Allow the battery pack to dry or wipe it
dry.
The chain saw does not run or run
continuously.
2. The battery pack is not fully installed
into the chain saw.
2. Remove and then replace the battery
pack into the chain saw making sure
that it is fully installed and latched.
The battery pack shows only 3 LED
indicators after only a few seconds of
using a fully charged battery. 1. This is a normal occurrence. 1. Shut off the tool and press
battery-charge-indicator button or
the remove the battery from the tool to
display the actual battery charge.
All 4 LED indicators are blinking on
the battery pack after you press the
battery-charge-indicator button on the
battery pack and the current charge
displays (when the battery pack is not in
use). 1. The battery pack is over or under the
appropriate temperature range.
1. Move the battery pack to a place
where it is dry and the temperature is
between 0°C (32°F) and 50°C (122°F).
All 4 LED indicators are blinking on the
battery pack after releasing the trigger
(when the battery pack is in use). 1. The battery pack is over or under the
appropriate temperature range.
1. Move the battery pack to a place
where it is dry and the temperature is
between 0°C (32°F) and 50°C (122°F).
20