Toro Power Plex 51880, Руководство оператора

Страница: 13 / 24

SUPERCEDED
Bucking a Log
•
If you are cutting branches from a fallen tree or cutting
a log into lengths, support the log off the ground
(preferably on a sawbuck); refer to
Figure 19 .
g194820
Figure 19
•
If the log is supported on an end, cut from the top. If the
chain saw binds in the cut, do not attempt to free it by
running the motor. Shut off the saw, then use a wedge to
pry open the cut and release the saw.
•
If the log is supported on both ends, start from the top
and cut about a third of the way through the log (
Figure
19 A). Make a second cut from the underside to meet the
first cut ( Figure 19 B). This keeps the log from pinching
the saw.
•
If the log is supported along its entire length, cut all the
way through the log from the top.
•
If the log is supported on both ends but not in the middle,
cut a third of the diameter from the top, then either cut
from the bottom or roll the log over to meet the first cut
(
Figure 20 ).
g194819
Figure 20
•
If the log is on a hill, always stand on the uphill side of
the log (
Figure 21 ).
g024807
Figure 21
1. Direction of slope
13