Toro Greensmaster 3250-D 04383, Руководство по обслуживанию, Страница: 23 / 308

Greensmaster 3250−D Page 3 − 9 Engine
Change Engine Oil and Filter
Change oil and filter initially after the first 50 hours of op-
eration, thereafter change oil every 50 hours and filter
every 100 hours. However, change oil more frequently
when engine is operated in extremely dusty or dirty
conditions.
1. Remove drain plug letting the oil flow into the drain
pan. When the oil stops flowing, install drain plug.
2. Remove oil filter. Apply a light coat of clean oil to the
new filter gasket.
3. Screw filter on by hand until the gasket contacts the
filter adapter. Tighten filter from 1/2 to 3/4 of a turn fur-
ther. Do not overtighten.
4. Add oil to crankcase (see Check Engine Oil).
5. Dispose of oil properly.
Figure 10
1. Drain plug 2. Oil filter
2
1
Replace Fuel Filter
Change filter every 800 hours. Use the following proce-
dures when replacement becomes necessary:
1. Close fuel shut−off valve.
DANGER
Because diesel fuel is flammable, use caution
when storing or handling it. Do not smoke while
filling the fuel tank. Do not fill fuel tank while en-
gine is running, hot, or when machine is in an en-
closed area. Always fill fuel tank outside and
wipe up any spilled diesel fuel before starting the
engine. Store fuel in a clean, safety−approved
container and keep cap in place. Use diesel fuel
for the engine only; not for any other purpose.
2. Clean area where filter canister mounts.
3. Disconnect sensor wire and remove drain plug.
4. Remove filter canister and clean mounting surface.
5. Lubricate gasket on filter canister with clean oil.
6. Install filter canister by hand until gasket contacts
mounting surface, then rotate an additional 1/3 turn.
Figure 11
1. Fuel filter
2. Priming pump
3. Drain Plug
2
1
3
7. Install drain plug with new o-ring. Connect sensor
wire.
8. Push primer button until resistance is felt.
9. Start engine and check for leaks.
Engine