Toro Greensmaster 3250-D 04383, Руководство по обслуживанию

Страница: 214 / 308

Greensmaster 3250−D
SPA and 4−Bolt Cutting Units (Rev. A)
Page 7 − 14
4. Position both front brackets as follows:
Note: The top side plate hole and top bracket hole
should yield Position 2 (standard setting).
A. Insert eccentric bolt (shoulder bolt) through one
of the two positions in the figure 8 hole in the frame
and one of the top holes of the front bracket (Fig. 31)
so the point on the bracket is at the desired position.
B. Screw lock nut onto the eccentric bolt (shoulder
bolt).
C. Insert carriage screw through the bottom hole of
the frame and front bracket. Secure carriage screw
and eccentric bolt (shoulder bolt) with lock nuts.
5. Level front roller to the reel (see Adjust and Level
Front Roller to Reel).
1. Front bracket
2. Eccentric (shoulder) bolt
3. Lock
nut
4. Lock nut
5. Carriage screw
Figure 31
5
2
3
4
1
Adjust Top Shield Height
Note: The top shield can be raised for extremely wet
conditions.
1. Loosen cap screws and nuts securing top shield to
each side plate.
2. Adjust top shield to desired position and secure fas-
teners.
3. Repeat above steps for the remaining cutting units.
IMPORTANT: The top shield must be adjusted every
time the top shield is adjusted.
1. Top shield 2. Lock nut
Figure 32
1
2
Adjust Top Bar
Adjust top bar, which is located on the rear bottom of the
top shield, to make sure clippings are cleanly dis-
charged from the reel.
IMPORTANT: The top bar is adjustable to compen-
sate for changes in turf conditions. The bar should
be adjusted closer to the reel when turf is extremely
wet. When turf conditions are dry, adjust the top bar
further away from the reel.
1. Loosen screws securing the top bar to the top
shield.
Note: Make sure gap between the bar and reel is the
same for the entire length of the reel.
2. Insert 0.060 inch (1.52 mm) feeler gauge between
the top of the reel and top bar. Tighten all screws.
3. Repeat above steps on remaining cutting units.