Toro Greensmaster 3250-D 04383, Руководство по обслуживанию

Страница: 116 / 308

Greensmaster 3250--D Hydraulic System (Rev. I) Page 4 -- 78
Reel Motor Service (Serial Number Over 230000000)
1. Rear cover
2. Drive gear
3. Seal
4. Tab washer
5. Pressure seal
6. Back--up ring
7. O--ring
8. Body
9. Idler gear
10. Cap screw
11. Front flange
12. Washer (if equipped)
Figure 47
7
4
3
1
2
5
6
9
10
11
(24 to 32 N--m)
215 to 280 in--lb
8
5
6
7
12
Disassembly
1. Plug motor ports and clean the outside of the motor
thoroughly. After cleaning, remove plugs and drain any
oil out of the motor.
2. Use a marker or scribe to make a diagonal mark
across the front flange, body, and rear cover for reas-
sembly purposes (Fig. 48).
IMPORTANT: Avoid using excessive clamping
pressure on the motor flange to prevent distorting
the casting.
3. Clamp mounting flange of motor in a vise with the
shaft end down.
4. Loosen cap screws on the rear cover.
5. Take motor from the vise and remove cap screws.
6. Remove front flange from the body, then remove rear
cover. Locate and remove dowel pins from body.
Figure 48
DIAGONAL MARK