Toro Greensmaster 3250-D 04383, Руководство по обслуживанию

Страница: 155 / 308

Greensmaster 3250--D Hydraulic System (Rev. I) Page 4 -- 117
5. Remove cap screw and flat washer securing the
console shroud to the hydraulic tank. Remove both cap
screws and flat washers securing the console shroud to
the lower panel (Fig. 87).
6. Remove three hex head screws and flat washers
securing the mounting plate (29) to the frame. Two
screws are located on the top of the plate at the front cor-
ners of the fuel tank. The third screw is in front of the cas-
tor fork and below the plate.
7. Tilt mounting plate (29) up by lifting at the rear of the
machine. Prop up plate securely. Remove four cap
screws (16) and flat washers (12) securing the hydraulic
tank (6) to the mounting plate.
8. Remove hydraulic tank (6) from the mounting plate
(29).
Inspecting Reservoir Parts (Fig. 84)
1. Clean tank and filler screen with solvent.
2. Inspect tank for leaks, cracks, or other damage.
3. Replace hydraulic hoses if worn or leaking.
4. Make sure cap screws are secure. If loose, remove
and reinstall cap screws with “Loctite 242” or equivalent.
5. Make sure all bracket fasteners are tight.
Installing Hydraulic Reservoir (Fig. 84)
1. Place antiseize lubricant into all four inserts at the
bottom of the hydraulic tank (6). Position tank onto the
mounting plate (29).
2. Secure hydraulic tank to the mounting plate with
four cap screws (16) and flat washers (12). Torque cap
screws from
30 to 60 in--lb (3.4 to 6.8 N--m)
.
3. Secure mounting plate (29) to the frame with three
hex head screws and flat washers Two screws go on the
top of the plate at the front corners of the fuel tank. The
third screw goes in front of the castor fork and below the
plate.
4. Secure console shroud to the hydraulic tank with
cap screw and flat washer, and to the lower panel with
both cap screws and flat washers (Fig. 87).
5. Secure return hose (21) to hydraulic barb fitting (9)
with hose clamp (23).
6. Secure pump inlet hose to hydrostat with hose
clamp (Fig. 85).
7. Connect hose assembly to the hydraulic fitting
welded to the reel motor case drain tube located below
the right side of the frame (Fig. 86).
Figure 85
PUMP INLET HOSE
1. Hose assembly 2. Case drain tube
Figure 86
1
2
WELDED
FITTING
1. Cap screw
2. Cap screw
3. Flat washer
4. Console shroud
5. Hydraulic tank
6. Lower panel
Figure 87
2
3
3
1
4
5
6
Hydraulic System