Toro Greensmaster 3250-D 04383, Руководство по обслуживанию

Страница: 276 / 308

Greensmaster 3250−D Groomer (DPA Cutting Unit) (Rev. D) Page 7.2 − 12
Groomer Reel Bearing Replacement
Figure 13
1. Drive side plate (LH shown)
2. Oil
seal
3. Groomer reel bearing
4. Grease fitting
5. Bushing
6. Side plate bushing
7. Non−drive side plate (RH shown)
2
3
4
5
6
1
2
2
3
5
6
7
Seal lip
3
(toward center of
cutting unit)
Seal lip
(toward center of
cutting unit)
Seal lip
(toward center of
cutting unit)
Note: The groomer reel drive is located on the oppo-
site side of the cutting unit from the cutting reel hydraulic
motor. Figure 13 shows the groomer reel drive from the
left side of the cutting unit.
Bearing Removal
1. Remove front roller, drive side groomer side plate
and groomer reel from cutting unit (see Groomer Reel
Removal in this section).
2. Remove non−drive groomer side plate from cutting
unit:
A. Remove hydraulic reel motor from cutting unit
(see Hydraulic Reel Motor Removal in the Service
and Repairs section of Chapter Chapter 7.1 − Dual
Point Adjust Cutting Units).
B. Remove two (2) socket head screws and lock
nuts that secure motor mount to cutting unit (Fig. 14).
Remove motor mount from cutting unit.
C. Remove lock nut and spring washer that secure
groomer arm lift rod to non−drive groomer side plate
(Fig. 15). Remove non−drive groomer side plate
from mower.
3. Remove bearings in both side plate assemblies
(Fig. 13):
A. Remove seals from groomer side plates. Discard
seals.
B. Push bearings out of side plate housings. Bear-
ings in drive side plate are a press fit. Bearings in
non−drive side plate are slip fit. Discard bearings.