Toro Greensmaster 3250-D 04383, Руководство по обслуживанию

Страница: 212 / 308

Greensmaster 3250−D
SPA and 4−Bolt Cutting Units (Rev. A)
Page 7 − 12
Adjust and Level Front Roller to Reel
1. If the cutting unit is not removed from the machine,
remove reel motor from the cutting unit and cutting unit
from lift arm (see Cutting Unit Removal and Installation).
Note: Make sure leveling plate covers the full length
of reel blades. Three blades must contact the plate.
2. Position cutting unit on a cutting leveling plate or a
known flat and level surface.
3. Position a 1/4−inch or thicker bar stock under the
reel blades and against the front face of the bedknife.
Note: Make sure both front brackets are in the same
hole (see Attitude Adjustment).
4. Loosen both lock nuts securing the right front brack-
et.
Note: The right front bracket is secured to the frame
with an eccentric bolt, while the left front bracket is se-
cured with a shoulder bolt. The eccentric bolt has an off-
set, which when rotated, acts as an eccentric (cam) to
raise or lower the roller. On the bolt head there is an
identification dot which denotes the offset of the bolt.
The dot indicates in which direction the right end of roller
moves when bolt is turned.
5. While holding reel securely on plate and maintain-
ing pressure on front roller, rotate upper right roller
mounting bolt. This mounting bolt has an offset, which
when rotated, acts as an eccentric (cam) to raise or low-
er the roller. On the bolt head there is an I.D. dot which
denotes the offset of the bolt. The dot indicates in which
direction right end of roller moves when bolt is turned.
1. Lock nuts
2. Right front roller bracket
3. Eccentric bolt
Figure 26
2
3
1
Note: If additional adjustment is required, replace
shoulder bolt on the left front bracket with another ec-
centric bolt (see cutting unit parts catalog for current part
number). Make sure both front roller brackets are in the
same hole.
6. Verify roller is level. Insert a piece of paper or 0.003
inch (0.076 mm) feeler gauge under each end of the roll-
er.
7. When the roller is level, tighten lock nuts securely.