Toro GrandStand TURBO FORCE 74513, Руководство оператора

Страница: 47 / 60

g031401
Figure 70
1. Hydraulic-tank cap 2. Fill level
4. Remove the cap from the filler neck ( Figure 70 ).
Note:
Look inside to check the fluid level in
the reservoir.
5. Add fluid to the reservoir until it reaches the
reaches the minimum cold fill level.
6. Install the cap on the filler neck.
Replacing the Hydraulic
Fluid and Filters
Service Interval: After the first 50 hours
Every 500 hours/Yearly (whichever comes
first)—Change the hydraulic filters and hydraulic
fluid.
Change the hydraulic fluid more frequently in severe
conditions or in a hot operating climate. Contact
your Authorized Service Dealer for a hydraulic kit to
replace the hydraulic filters.
WARNING
Hot hydraulic fluid can cause severe burns.
Allow the hydraulic fluid to cool before
performing any maintenance on the hydraulic
system.
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the fuel tank; refer to Removing the
Fuel Tank (page 35) .
4. Remove the hydraulic-reservoir cap.
5. Locate the drain plug in the bottom of each
transmission and place a drain pan under the
plugs (
Figure 71 ).
g032671
Figure 71
1. Drain plug 2. Hydraulic filter
6. Remove the drain plugs.
7. Allow the hydraulic fluid to fully drain from the
machine.
8. Remove the hydraulic filter cap and filter from
each transmission.
9. Install new hydraulic filters with the spring side
facing out and install the filter caps.
10. Install the drain plugs and torque to 22 to 27
N∙m (16 to 20 ft-lb).
11. Loosen the vent plug in each transmission so
that it is loose and wobbles (
Figure 72 ).
Note:
This allows air to escape the hydraulic
system as you add hydraulic fluid.
g031544
Figure 72
Left transmission shown
1. Vent plug
12. Slowly add fluid to the hydraulic tank until it
starts to come out 1 of the vent plugs.
47