Toro GrandStand TURBO FORCE 74513, Руководство оператора

Страница: 20 / 60

Adjusting the Height-of-Cut
The height-of-cut can be adjusted from 38 to 127 mm
(1-1/2 to 5 inches) in 6 mm (1/4 inch) increments.
Note:
Using a height-of-cut under 51 mm (2 inches)
increases the wear on the mower-deck belt. Use a
height-of-cut that is greater than 51 mm (2 inches)
whenever possible.
g030985
Figure 21
Adjusting the Anti-Scalp
Rollers
Models with a 60-Inch Deck Only
Whenever you change the height-of-cut, adjust the
height of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
EUTRAL
-
LOCK
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the nut and bolt position the anti-scalp
rollers and install the nut and bolt.
4. Ensure that the spacers and bushings are
installed (
Figure 22 ).
g018324
Figure 22
1. Bushing 4. Bolt
2. Anti-scalp roller 5. Nut
3. Spacer
Adjusting the Flow Baffle
You can adjust the mower-discharge flow for different
types of mowing conditions. Position the cam lock
and baffle to provide the best quality of cut.
1. Disengage the PTO, move the motion-control
levers to the N
EUTRAL
-
LOCK
position, and
engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. To adjust the baffle, loosen the nut ( Figure 23 ).
4. Adjust the baffle and nut in the slot to the desired
discharge flow and tighten the nut.
20