Toro 74923 Z Master 6000, Руководство оператора

Страница: 43 / 68

Installing the Battery
Note:
Position the battery in the tray with the terminal posts
opposite from the hydraulic tank ( Figure 58 ).
Figure 59
Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important:
Always keep the battery fully charged (1.265
specific gravity). This is especially important to prevent
battery damage when the temperature is below 0°C
(32°F).
1. Charge battery for 10 to 15 minutes at 25 to 30 A or
30 minutes at 10 A.
2. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts (
Figure 60 ).
3. Install the battery in the machine and connect the
battery cables; refer to
Installing the Battery (page 43) .
Note:
Do not run the machine with the battery
disconnected, electrical damage may occur.
Figure 60
1. Positive battery post 3. Red (+) charger lead
2. Negative battery post 4. Black (-) charger lead
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
1. The fuses are located on the console to the right of
the seat (
Figure 61 ).
2. To replace the fuses, pull out on the fuse to remove it.
3. Install a new fuse ( Figure 61 ).
Figure 61
1. Optional accessory—15 A
4. Main—25 A
2. Charge—25 A 5. Console
3. PTO—10 A
43