Toro 74923 Z Master 6000, Руководство оператора

Страница: 25 / 68

2. Push on the deck-lift pedal with your foot, and raise
the mower deck to the transport position (also the 140
mm (5-1/2 inches) cutting height position) as shown
in
Figure 27 .
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket (
Figure 27 ).
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired, and insert the pin (
Figure
27 ).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
Figure 27
1. Deck-lift pedal
3. Transport lock
2. Cut-of-height pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
EUTRAL
-
LOCK
position,
and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Adjust the anti-scalp rollers as shown in Figure 28 ,
Figure 29 , and Figure 30 .
Figure 28
1. Anti-scalp roller 4. Flange nut
2. Spacer
5. Bolt
3. Bushing
Figure 29
1. Anti-scalp roller 3. Flange nut
2. Bushing 4. Bolt
Figure 30
1. Anti-scalp roller 4. Flange nut
2. Spacer 5. Bolt
3. Bushing
25