Toro 74923 Z Master 6000, Руководство оператора

Страница: 26 / 68

Adjusting the Flow Baffle Cam
Locks
This procedure is applicable only to machines with the
flow-baffle locks. Certain models have nuts and bolts in place
of the flow-baffle locks and can be adjusted the same.
You can adjust the mower-discharge flow for different types
of mowing conditions. Position the cam locks and baffle to
give the best quality of cut.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
EUTRAL
-
LOCK
position,
and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. To adjust the cam locks, swing the lever up to loosen
the cam lock (
Figure 31 ).
4. Adjust the baffle and cam locks in the slots to the
desired discharge flow.
5. Swing the lever back over to tighten the baffle and cam
locks (
Figure 31 ).
6. If the cam locks do not lock the baffle into place or it is
too tight, loosen the lever and then rotate the cam lock.
Note:
Adjust the cam lock until the desired locking
pressure is achieved.
Figure 31
Position A
This is the full rear position. The suggested use for this
position is as follows:
•
Short, light grass mowing conditions
•
Dry conditions
•
Smaller grass clippings
•
Propels grass clippings farther away from the mower
Figure 32
Position B
Use this position when bagging. Always align it with the
blower opening.
Figure 33
Positioning the Flow Baffle
The following figures are only recommendations for use.
Adjustments vary by grass type, moisture content, and the
height of the grass.
Note:
If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position C
This is the full open position. The suggested use for this
position is as follows:
•
Tall, dense grass mowing conditions
•
Wet conditions
•
Lowers the engine-power consumption
•
Allows increased ground speed in heavy conditions
26