Toro 74923 Z Master 6000, Руководство оператора

Страница: 21 / 68

Starting the Engine
1. Raise the ROPS up and lock into place, sit on the seat,
and fasten the seat belt.
2. Move the motion controls to the N
EUTRAL
-
LOCK
position.
3. Set the parking brake; refer to Setting the Parking
Brake (page 19) .
4. Move the blade-control switch (PTO) to the O
FF
position ( Figure 19 ).
5. Move the throttle lever midway between the S
LOW
and
F
AST
positions.
A
B
C
D
E
G
F
H
g032328
Figure 19
6. Turn the ignition key to the S
TART
position ( Figure 20 ).
Note:
When the engines starts, release the key.
Important:
Do not engage starter for more than 5
seconds at a time. If the engine fails to start allow
a 15-second cool-down period between attempts.
Failure to follow these instructions can burn out
the starter motor.
Note:
Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
ST
ART
RUN
ST
OP
G008947
Figure 20
Starting and Stopping the
Engine
Stopping the Engine
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Let the engine idle at slow throttle (turtle) for 60 seconds
before turning the ignition switch to the O
FF
position.
21