Toro 74833, Руководство оператора

Страница: 44 / 52

stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
Lower the mower to the 3 inch (76 mm) height-of-cut
position. Remove the mower belt from the engine
pulley; refer to the Replacing the Mower Belt procedure.
Lower the mower to the lowest height-of-cut. Select one
of the following procedures depending on the mower
deck size installed to complete the removal.
1. Remove the hair pin cotter and washer securing the
long, link bar to the frame and deck; remove the link
bar (Figure 62).
G010309
1
2
3
Figure 62
1. Hair pin cotter 3. Link bar
2. Washer
2. Remove the hardware from the front and rear deck
hangers on both sides of the deck (Figure 63).
G010305
1
2
3
4
1
2
3
4
Figure 63
1. Deck hanger 3. Washer
2. Hairpin cotter 4. Welded post on deck
3. Raise the height-of-cut to the transport position
4. Slide the mower out from underneath the machine.
Note:
Retain all parts for future installation.
Installing the Mower
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
neutral lock position, stop the engine, remove the
key, and wait for all moving parts to stop before
leaving the operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest position.
Place the height-of-cut pin in the lock position for
lowest height-of-cut.
5. Lift the rear of the mower deck and attach the rear
support on the mower deck to the rear deck hangers.
Secure them with a clevis pin and hairpin cotter
(Figure 63).
6. Attach the front support on the mower deck to the
front deck hangers and secure them with a washer
and hairpin cotter (Figure 62).
7. Install the long, link bar through the frame hanger
and deck. Secure the link bar with the hair pin
cotters and washers removed previously.
8. Install the mower belt onto the engine pulley; refer
to Replacing the Mower Belt.
Replacing the Grass Deflector
Service Interval: Before each use or daily—Inspect the
grass deflector for damage
WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator’s or
bystander’s direction and result in serious injury.
Also, contact with the blade could occur.
Never operate the lawn mower unless you install a
mulch plate, discharge deflector, or grass collection
system.
Inspect the grass deflector for damage before each use.
Replace any damaged parts before use.
1. Disengage the spring from the notch in the deflector
bracket and slide the rod out of the welded deck
44