Toro 74833, Руководство оператора

Страница: 24 / 52

G010229
1 2
3
4
Figure 29
1. Control arm shaft 3. Slotted, upper hole
2. Control lever
4. Bolt
3. Repeat the adjustment for the opposite control
lever.
Adjusting the Tilt
The motion control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever to
the control arm shaft.
2. Loosen the lower bolt just enough to pivot the
control lever fore or aft (Figure 29). Tighten both
bolts to secure the control in the new position.
3. Repeat the adjustment for the opposite control
lever.
G010337
Figure 30
Pushing the Machine by Hand
Important:
Always push the machine by hand.
Never tow the machine because damage may
occur.
To Push the Machine
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to neutral
lock position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position. Make sure the parking brake is
disengaged .
3. Locate the bypass levers at the rear of the machine,
on the left and right side of the frame.
4. Move the bypass levers rearward and then down
to lock them in place as shown in Figure 31 to
disengage the wheel motors. Repeat this on each
side of the machine.
The machine is now able to be pushed by hand.
G010230
G012087
2
3 4
1
Figure 31
To Operate the Machine
Move the bypass to the position for driving the machine
(Figure 31) to engage the wheel motors.
24