Figure 48
1.
Jack stands On Truckster Direct Connect
Using the Storage Stand
1.
Park the work vehicle in the storage spot for the
machine.
Note:
The storage spot must be a hard and level
surface.
2.
Disconnect the electrical connection from the work
vehicle.
3.
Disconnect the machine hydraulic lines from the work
vehicle.
4.
With the work vehicle in neutral gear, set the parking
brake and start the engine.
5.
Using the vehicle lift cylinder, raise the front of the
machine high enough to install the front storage stand
legs.
6.
Turn off the engine.
WARNING
Do not climb under or perform work on the
machine while it is on the storage stand.
7.
Insert the front storage legs and the rear jack stands
into the machine tubes and secure them with the
locking pins (
Figure 49
1.
Rear jack stands
3.
Locking pin
2.
Front storage legs
8.
Using the vehicle lift cylinder, lower the front of the
machine until the front storage stand legs begin to
touch the ground.
9.
Raise the two rear storage jack stands until the pressure
is off the mounting pins that secure the machine cross
tube to the Workman frame.
10.
Remove the rear lynch pins, hitch pins and washers
(
).
Figure 50
1.
Hitch pin, washers & lynch pin
11.
With one hand, hold the lift cylinder. With the other
hand, remove the lift cylinder’s locking pin (
32
