Reseting the Fault Code
After solving the problem, reset the fault codes by disconnecting and reconnecting diagnostic connectors. The
diagnostic light will flash continuously at 1 Hz (1 flash per second).
Exiting Diagnostic Mode
1.
Push the E-S
TOP
button down to turn off the power; refer to
(page )
.
2.
Disconnect the diagnostic, shunt connectors (
, B).
3.
Push the tethered cap onto the two diagnostic, shunt connectors (
, A).
4.
Pull the E-
STOP
up to turn on the power.
Handheld Remote Messages (EH Models Only)
Displayed Message
Description
ASSOC PENDING
Association yet to be made.
ASSOC ACTIVE
Association attempt in progress.
POWER UP BASE
Power up the Base Unit.
ASSOC PASS
Association attempt was successful.
ASSOC EXIT
Exiting Association mode
ASSOC FAIL
Association attempt failed.
PRESS STORE
Press the S
TORE
button.
ALL STORE
Store all current set values in current working memory.
OPTION STORE
Store the current Option settings in current working memory.
BELT STORE
Store the current Floor settings in current working memory.
PRESET 1 STORE
Store the current Preset 1 setting in current working memory.
PRESET 2 STORE
Store the current Preset 2 setting in current working memory.
PRESET 3 STORE
Store the current Preset 3 setting in current working memory.
WAITING FOR BASE
Remote is waiting for a Base Unit response.
HOPPER UP
Remote is sending Hopper Raise command.
HOPPER DOWN
Remote is sending Hopper Lower command.
PROPASS REV XX
Product to which the system is set to control.
MH400 REV XX
Product to which the system is set to control.
BAT XX%
Battery X.X V
Remaining battery life in percentage.
Remaining battery life in voltage.
CHANNEL X
Channel currently being used by the system.
HH ID XXXXXX
Identity of the Handheld Remote
BASE ID XXXXXX
Identity of the Base Unit
FLR XX%
OPT XX%
The current Floor speed in percent.
The current Option speed in percent.
FLRS XX%
OPTS XX%
Display of the stored regular Floor speed and Option speed with 0% command to the
output allowing the operator to decide to use the current setting or change it.
FLR OFF
OPT OFF
Displays the status of the floor and option when they are off.
SERVICE ACTIVE
The service tool is active.
SERVICE NO APP
Service has no valid application to run.
39
