Figure 44
Manual Override Decal
1.
Floor speed adjustment.
2.
Spinner speed adjustment.
•
To adjust the spinner speed (
), use a flat-head
screwdriver to increase by turning clockwise or decrease
by turning counter clockwise.
Note:
If adjusting with the hydraulic flow active, ensure that
the floor is turned off if you do not wish to have sand being
spread as you adjust.
Once your settings are acceptable, use the hydraulic flow
control on your tow vehicle to turn the system on and off
for operation.
Key Functionality Elements
•
When you turn the handheld remote on, the display
should read
FLR OFF
and
OPT OFF
in approximately 5
seconds. If the words “waiting for base” are in the display,
check to ensure there is electrical power to the base unit
and ensure the E-S
TOP
button on the base unit is out.
•
There is always a
current working memory
. This is not
the same as a preset. The last saved work settings will
be in the current working memory when you turn the
handheld remote on.
•
Operational sequence of the handheld remote start
buttons:
–
Pressing a start button once (A
LL
S
TART
, F
LOOR
S
TART
, or O
PTION
S
TART
) calls up the current
working memory setting stored in the handheld
remote.
–
By pressing the same start button a second time, the
component turns on if the hydraulics are engaged (it
shows numbers ramping up in the display).
–
Pressing the same start button a third time will store
the new setting established in the remote’s working
memory.
•
After pressing a start button once to view the current
working memory setting in a non-working mode, there is
approximately 10 seconds to begin adjusting the setting
or the element will revert back to off. In a working mode,
the 10 second rule does not apply.
•
To program a preset, you must have the elements
activated or engaged
first.
•
To operate from a preset, the you must have element
speed percentages in the display to activate or engage
them. If the word
OFF
is in the display, you must recall
the preset.
25
