Toro 41188, Руководство по обслуживанию

Страница: 47 / 353

Multi Pro 1750 Page 3 − 29 Kohler Gasoline Engine
Clutch Release Disassembly (Fig. 18)
1. Remove five (5) hex head screws, flat washers, and
flange nuts securing bearing support (item 27) to bell
housing. Remove bearing support assembly from bell
housing.
2. Remove clutch release bearing (item 14) from re-
lease fork.
3. Remove three (3) flange head screws securing re-
lease guide (item 26) to bearing support and remove re-
lease guide.
4. Remove retaining ring (item 32) and press output
shaft and bearing (item 33) from bearing support. Press
bearing from output shaft and discard bearing.
5. If necessary, remove two (2) roll pins from clutch re-
lease fork (item 20) and pull clutch release shaft
(item 24) and fork from bell housing.
If necessary, remove and discard roll pin from release
fork and remove and discard release shaft seals and
bushings from bell housing.
Clutch Release Assembly (Fig. 18)
1. Press new bearing onto output shaft (item 30) until
fully seated. Press bearing and output shaft assembly
into bearing support and install retaining ring (item 32).
2. Attach release guide (item 26) to bearing plate with
three (3) flange head screws. Tighten screws from 90 to
120 in−lbs (10 to 12 N−m). Apply anti seize lubricant to
shoulder of release guide, output shaft splines, and out-
put shaft pilot bearing surface.
3. If previously removed, press new roll pin (item 19) in-
to arm of release fork.
4. If previously removed. press new release shaft
bushings and seals (items 22 and 23) into bell housing.
Position release shaft lever and release fork arms up-
ward and slide release shaft (item 24) through bell hous-
ing and release fork. Press two (2) roll pins through
release fork and shaft.
5. Apply anti seize lubricant to inside groove and bore
of release bearing (item 33) and hang bearing on re-
lease fork.
6. Slide release bearing over release guide and fit bear-
ing support over alignment pins in bell housing. Make
sure release bearing remains fit over roll pin (item 19) in
release fork. Install bearing support assembly with five
(5) hex head screws, flat washers, and flange nuts.
Tighten flange nuts from 90 to 120 in−lbs (10 to 12
N−m).
Kohler
Gasoline Engine