Toro 41188, Руководство по обслуживанию

Страница: 272 / 353

Multi Pro 1750 Page 7 − 46 Drive Train
23.Measure countershaft end play. Rotate one of the
axle shafts back and forth to take up all back lash. Rotat-
ing the shaft in one direction will pull the shaft and bear-
ing away from the snap ring. Rotate axle shaft in this
direction, then measure space between the snap ring
and shim (set) with a feeler gauge. Make sure shim set
is pressed against the bearing during the measurement.
End play should be from 0.000 to 0.0039 in. (0.00 to
0.10 mm).
IMPORTANT: If end play is too great, replace shim/
shim set with thicker shims to allow correct end
play. If end play is too small, replace shim/shim set
with thinner shims to allow correct end play.
Figure 84
24.Insert sealing cap flush with face of center plate.
Make sure to not insert sealing cap too far. Pay attention
to direction of sealing cap.
1
1. Sealing cap
Figure 85
25.Install fork shaft case:
A. Thoroughly clean mating surface of transaxle
case and fork shaft case.
B. Insert spindle lock between fork shafts.
1
1. Spindle Lock
Figure 86