Toro 34242, Руководство оператора

Страница: 12 / 60

g387042
Figure 5
1. Rear reference bar
6. Throttle control
2. Left motion-control lever 7. Hour meter
3. Parking-brake lever 8. Right motion-control lever
4. Front reference/speed
control bar 9. Ignition switch
5. Choke control
Throttle Control
Located in the center of the control console ( Figure 5 ).
The throttle is used to control engine speed. Moving
the throttle lever forward will increase engine speed
and moving the throttle lever to the rear will decrease
engine speed. Moving the throttle forward into the
detent is full throttle.
Parking-Brake Lever
Located on the left side of the control console ( Figure
5 ).
The brake lever engages a parking brake in the
transaxle.
Pull the lever rearward to engage the brake.
Push the lever forward to disengage the brake.
When parking on a steep slope, the wheels must be
chocked or blocked in addition to the brake being
engaged. The machine must be tied down and brake
engaged when transporting.
Ignition Switch
Located in the center of the control console ( Figure 5 ).
The ignition switch is used to start and stop the
engine. The switch has three positions OFF, ONand
START. Insert key into switch and rotate clockwise to
the ON position. Rotate clockwise to the next position
to engage the starter (key must be held against spring
pressure in this position). Allow the key to return to
the ON position immediately after the engine starts.
Note:
The parking brake must be engaged and the
motion-control levers in neutral to start the engine.
Hour Meter
Located to the right of the throttle ( Figure 5 ).
The hour meter is connected to a charge circuit
installed in the engine block and it records the number
of hours that the engine has run. If ignition switch is
left on without engine running, the hour meter will
not run.
Impeller-Speed Control
Located on the left side of the control console (see
Figure 6 ).
Rotate the knob clockwise to start the impeller and
to increase the speed and pattern width. Rotate the
knob counterclockwise to decrease speed, pattern
width, and to turn the impeller off.
12