Toro 34242, Руководство оператора

Страница: 53 / 60

Maintaining the Sprayer
and Spreader Systems
Check Spreader System
Service Interval: Every 50 hours
Clean the bottom of the hopper with a wire brush and
clean off any fertilizer if needed.
Change out the hopper bottom bushing or the impeller
if needed.
Check Sprayer System
Service Interval: Every 50 hours
1. Stop engine, wait for all moving parts to stop,
and remove key. Engage parking brake.
2. Check all hoses, nozzles, and fittings for leaks.
3. Check nozzle strainers and in-line strainers.
4. Replace as needed.
Check In-line Filter
Periodically check the in-line filter for any debris in
the screen. If debris is present, this can create erratic
pressure spikes and/or not allow the proper flow
through system. After clearing any debris, ensure that
gasket remains intact and tighten in-line filter cap (if
not installed properly, this will allow air to get in the
system and system will lose or not create pressure).
g387358
Figure 46
1. Cap 3. O-ring (attached to cap)
2. Filter
4. In-line filter housing
Cleaning
Cleaning and Storing Safety
•
Park machine on level ground, disengage drives,
set parking brake, stop engine, and remove key.
Wait for all moving parts to stop before leaving
the operator’s position. Allow the machine to cool
before servicing, adjusting, fueling, unclogging,
cleaning, or storing.
•
Clean grass and debris from the muffler, drives,
and engine compartment to prevent fires.
•
Allow the machine to cool before storing the
machine in any enclosure. Do not store the
machine or fuel container, or refuel, where there
is an open flame, spark, or pilot light such as on a
water heater or other appliance.
Clean Engine and Exhaust
System Area
Service Interval: Before each use or daily (May be
required more often in dry or dirty
conditions.)
CAUTION
Excessive debris around engine cooling air
intake and exhaust system area can cause
engine, exhaust area, and hydraulic system to
overheat which can create a fire hazard.
Clean all debris from engine and exhaust
system area.
1. Stop engine, wait for all moving parts to stop,
and remove key. Engage parking brake.
2. Clean all debris from rotating engine air intake
screen, around engine shrouding, and exhaust
system area.
3. Wipe up any excessive grease or oil around the
engine and exhaust system area.
4. Clean muffler heat shields of all debris, dirt, and
oil.
Remove Engine Shrouds
and Clean Cooling Fins
Service Interval: Every 80 hours
1. Stop engine, wait for all moving parts to stop,
and remove key. Engage parking brake.
53