Toro 04861, Руководство по обслуживанию

Страница: 190 / 234

Installing the Reel Assembly (continued)
g323557
Figure 113
1. RH reel nut 3. Support plate, weld side
2. Reel shaft 4. Pry bar
A. Insert a long- handled pry bar (3/8 x 12 inch with a screwdriver handle
recommended) through the front of the cutting unit. The pry bar should
pass between the top of the reel shaft and the backs of the reel blades so
that the reel will not move; refer to
Figure 113 .
IMPORTANT
To avoid grinding the reel, do not contact the cutting edge of
any blade with the pry bar as this may damage the cutting edge
and/or cause a high blade.
B. Move the pry bar against the weld side of the reel support plate closest to
the reel nut being tightened.
IMPORTANT
The reel nut on the left end of the cutting reel has left- hand
threads. The reel nut on the right end of the cutting reel has right-
hand threads.
C. Rest the handle of the pry bar against the front roller and tighten the reel
nut from 123 to 149 N·m (90 to 110 ft-lb) .
D. Position the pry bar in the same manner on the opposite end of the reel
and tighten the other reel nut from 123 to 149 N·m (90 to 110 ft-lb) .
10. Check to make sure the rear roller and cutting reel are parallel; refer to
Leveling the Rear Roller (page 7–4) .
11. Install the reel drive assembly; refer to Installing the Reel Drive Assembly
(page 4–10) . Grease the splines with high temp Mobil XHP−222 grease
or equivalent.
12. Install the cutting unit assembly to the machine; refer to the traction unit
Operator’s Manual .
DPA Cutting Units: Service and Repairs Page 7–24 Greensmaster ® eFlex 1021
20248SL Rev C