Toro 04861, Руководство по обслуживанию

Страница: 127 / 234

Servicing the Electric Motor
g293229
Figure 68
1. Cap screw (6 each) 7. Bearing
2. Motor cover 8. O-ring
3. O-ring 9. Housing assembly
4. Wave washer 10. Lip seal
5. Bearing 11. O-ring
6. Rotor
Note: If the motor housing, controller, or cable damage occurs, the electric motor
replacement is necessary. These components are not available separately.
Note: If problems with electric motor exist, an advisory or fault may be identified
on the InfoCenter display. Refer to the InfoCenter Display (page 5–10) for
information on advisories and faults.
Use of the motor rotor tool part number TOR6028 is recommended for this
procedure: refer to
Special Tools (page 2–13) .
Note: When servicing the electric motor, use a clean workspace with a non-metal
surface. The motor rotor includes very powerful magnets that can cause the rotor
to move unexpectedly if working on a metal surface. Also, any metallic debris
that gets attracted to the rotor can damage the motor after assembly.
Disassembling the Electric Motor
Refer to Figure 68 for this procedure.
1. Inspect the electric motor cable for wear or damage. Replace cable
components or complete electric motor assembly if necessary.
2. Carefully remove and discard the lip seal from the housing assembly.
3. Remove the six cap screws that secure the motor cover to rear of motor
housing. Do not remove the motor cover.
Greensmaster ® eFlex 1021 Page 5–43 Electrical System: Service and Repairs
20248SL Rev C