Toro 04861, Руководство по обслуживанию

Страница: 173 / 234

Removing the Bedbar
Note: Refer to Figure 99 during this procedure.
1. Remove the cutting unit from the machine and place the cutting unit on a flat
work surface; refer to Operator’s Manual .
2. Loosen the nuts (11) on the end of each bedbar adjuster assembly (1) until
the washers (9) are loose.
3. Tip the cutting unit to expose the bedknife and support the rear of the cutting
unit; refer to Supporting the Cutting Unit when Servicing (page 7–2) .
g313909
Figure 100
1. Side plate 6. Bedbar
2. Rubber bushing 7. Bedbar pivot bolt
3. Nylon bushing 8. Lock nut
4. Plastic washer (2 each) 9. Bed knife
5. Metal washer 10. Screw (13 each)
4. Loosen the lock nuts (item 8 in Figure 100 ) on each bedbar bolt (7).
5. Remove the two bedbar bolts (item 7 in Figure 100 ), two flat washers (5) and
four plastic washers (4) from the cutting unit side plates (1).
CAUTION
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury. Use heavy gloves when handling the bedbar.
6. Remove the bedbar assembly (8) from the cutting unit.
7. Inspect the nylon bushings (item 3 in Figure 100 ) and rubber bushings (4) in
the side plates for wear or damage. Replace the bushings if necessary.
Greensmaster ® eFlex 1021 Page 7–7 DPA Cutting Units: Service and Repairs
20248SL Rev C