Toro 04861, Руководство по обслуживанию

Страница: 186 / 234

Removing the Reel Assembly (continued)
IMPORTANT
To avoid grinding the reel, do not contact the cutting edge of
any blade with the pry bar as this may damage the cutting edge
and/or cause a high blade.
C. Move the pry bar against the weld side of the reel support plate closest to
the reel nut being removed.
IMPORTANT
The LH reel nut (with drive shaft) on the left end of the cutting
reel has left- hand threads. The reel nut on the right end of the
cutting reel has right- hand threads.
D. Rest the handle of the pry bar against the front roller and loosen the
reel nut.
E. Position the pry bar in the same manner on the opposite end of the reel
and loosen the remaining reel nut.
F. Tip the cutting unit back onto its roller.
8. Remove the bedbar; refer to Removing the Bedbar (page 7–7) .
9. Remove the front roller; refer to Removing the Front Roller (page 7–27) .
10. Remove the rear roller; refer to Removing the Rear Roller (page 7–28) .
11. Support the cutting reel to prevent it from shifting or falling and remove the 2
socket head screws (3) that secure the LH side plate (4) to the crossmember
(13).
12. Remove the 2 socket head screws (3) that secure the RH side plate (21) to
the crossmember (13).
13. Remove the crossmember (13) from the reel assembly (19).
14. If necessary, remove the three bolts (15) that secures the grass shield (14) to
the crossmember (13). Remove the grass shield (14) from the crossmember
(13).
15. Carefully slide the cutting reel assembly (with seals, bearings, and reel nuts)
from the side plates. Retrieve the flat wire spring from the reel bearing bore
of the left side plate.
16. Thoroughly clean any grease and corrosion from the reel bearing bores in
the side plates.
17. Inspect the remaining cutting unit components for corrosion, wear, or damage
and replace the components as necessary.
DPA Cutting Units: Service and Repairs Page 7–20 Greensmaster ® eFlex 1021
20248SL Rev C