4
-1# #$1 ," /'%&1 0'"#0 -$ + !&',# /#$#/ 1- ,-/+ *
-.#/ 1',% .-0'1'-,
- ,01 ** ,"*#
Remove capscrew, washer and lockwasher from
mounting pin on each side of mower, as shown in fig. 1.
Remove capscrews and locknuts securing bottom
of handle arms to each side of mower, as shown in
fig. 1.
Remove hair pin cotters and ring pins securing
handle arms to rear of frame (Fig. 1).
-2,1',% .',0
,"*# /+0
'%2/#
.0!/#3 *-!),21
'/ .', !-11#/ /',% .',
Insert handle ends thru holes in handle arms and
align holes with mounting pins (Fig. 1).
Squeeze handle ends inward and install on
mounting pins (Fig. 2).
'%2/#
,"*# #,"
Secure handle ends to mounting pins with
capscrews, washers and lockwashers previously
removed (Fig. 2).
Secure bottom of handle arms to each side of
mower with capscrews and locknuts, previously
removed (Fig. 2). Make sure bushings are installed in
handle arm mounting holes. Do not overtighten
capscrews as handle arms must pivot freely.
Secure handle arms to rear of frame with hair pin
cotters and ring pins previously removed (Fig. 2).
Secure cables to handle with cable ties.
- "(201 ,"*#
Remove hairpin cotters from ring pins on each side
of mower (FIg. 2).
While supporting handle, remove ring pins from
each side and raise or lower handle to desired
operating position. (Fig. 2).
Reinstall ring pins and hair pin cotters.
Push kick stand down with foot and pull up on
handle to support mower on kick stand.
Apply #242 Loctite to threads of wheels shafts.
Thread right hand wheel shaft into drive pulley on
right side of machine. Torque shaft to 65-75 ft-lb.
'%2/#
&##* 0& $1
-1#
The right hand wheel shaft has Left Hand
Threads.
Apply Never-Seez to the exposed ends of axles
and slide wheel onto axle (Fig. 4).
Pivot wheel locking clip away from center of wheel
allowing wheel to slide farther onto axle (Fig. 4).
Rotate wheel back and forth until it slides
completely onto axle and locking clip is secured in
groove on axle shaft.
-!)',% !*'.
'%2/#
Repeat procedure on opposite side of machine.
Tires to be inflated to 12-15 psi.
