To operate the controls while mowing:
Start the engine, set the throttle at reduced speed,
push down on handle to raise cutting unit, move
traction lever to ENGAGED position and transport
mower onto collar of green.
Move traction lever to DISENGAGED position and
ENGAGE reel drive lever.
Move traction lever to ENGAGED position,
increase throttle speed until the mower is traveling at
the desired ground speed, drive the mower out onto
the green area, lower the front of the mower down and
commence operation.
Drive off green, move traction control lever to
DISENGAGE, stop the engine and push the reel drive
lever into DISENGAGED position.
Empty the grass catcher of clippings, install grass
catcher and commence transport operation, refer to
Transport Operation.
The (13) grease fittings on the mower should be
greased at least every 25 hours. Lubricate using No. 2
multi-purpose lithium base grease. A hand operated
grease gun is recommended for best results.
Wipe each grease fitting with a clean rag.
The grease fitting locations are: (2) on Front Roller
(Fig. 22), (2) on reel bearings (Fig. 22), (2) on Drum
Axles (Fig. 23), (3) on Differential (Fig. 23), (2) on Reel
Countershaft Bearings (Fig. 24) and (2) on Belt Idler
Pivots (Fig. 25).
& %&* ''#- *&& $+! '())+( &(
() )#) ,"## &$ '($%%*#- $
Wipe off excess grease.
" +(
" +(
" +(
" +(