&21 #+%'+# ,$$ 4'1 $,/ )) *,3'+% -/10 1,
01,- +" "'0!,++#!1 0-/( -)2% 4'/# '%
#$,/# -#/$,/*'+% +5 *'+1#++!# -/,!#6
"2/#0 ,+ 1&# *,4#/
'%2/#
-/( )2%
The Engine Manual supplied with your Greensmaster
1600 provides the maintenance procedures for service
of the air cleaner, oil requirements, ignition
components, etc.
The TORO Company recommends that the oil level be
checked each time mower is used or after every 5
operating hours. Initially, change oil after the first 8
hours of operation; thereafter, change oil after every 50
hours of operation.
,/# $/#.2#+1 ,') !&+%#0 /#
/#.2'/#" '+ "2015 ,/ "'/15 !,+"'1',+0
') )#3#) %2%#
/'+ -)2%
'%2/#
, !&#!( ,') )#3#)
Position mower so the engine is level and clean
around oil level gauge (Fig. 27).
Remove oil level gauge by rotating it
counterclockwise.
. Wipe oil level gauge clean and insert it into filler
port. Do not screw into port. Then remove and check
level of oil. If level is low, add only enough oil to raise
level to filler opening.
Reinstall oil level gauge and wipe up any spilled oil.
, !&+%# ,')
Start and run engine for a few minutes to warm the
engine oil.
Place a drain pan at rear of machine under drain
plug (Fig. 27). Remove drain plug.
Push down on handle to tip mower and engine
backward, allowing more oil to run into drain pan.
Reinstall drain plug and refill crankcase with
proper oil: refer to Check Oil Level.
Normally, clean air cleaner after every 25 operating
hours. More frequent cleaning is required when mower
is operated in dusty or dirty conditions.
Make sure wire is off spark plug.
Remove wing nuts securing air cleaner cover to air
cleaner and remove cover. Clean cover thoroughly
(Fig. 28).
'%2/#
'/ !)#+#/ !,3#/
If foam element is dirty, remove it from paper
element (Fig. 29). Clean thoroughly.
