Toro 04042, Руководство по диагностике

Страница: 26 / 136

Figure 31
Main Harness P43 Connector Pin Identification
Main Harness Wireless Hour Meter P43 Connector
Pin Identification Description Wire Color
1 12 Vdc In Pink (PK)
2 Not used Not used
3 Ground Black (BK)
Pass 12 Vdc measured good at the listed location. Go to step 4.3.
Fail 12 Vdc did not measure good at the listed location. Repair or replace worn or
damaged parts as required. Go to
Returning the Equipment to Service (page 19) and
follow the steps listed.
Step 4.3: Test for 12 Vdc on the wire harness connector for the EZ-Turn
proximity sensor.
Test for 12 Vdc on the wire harness connector for the EZ-Turn proximity sensor ( Figure 32 ) by performing the
following:
1. Rotate the key switch to the O
FF
position, and then disconnect the main wire harness P23 connector at the
EZ-Turn proximity sensor.
2. Rotate the key switch to the S
TART
position and hold it there until the InfoCenter LCD display lights up, then
release the key switch to the R
UN
position.
3. Measure the voltage between the main wire harness P23 connector, pin A, and the main wire harness P04
connector, pin B. The range for a good reading is 10.5 to 13.8 Vdc.
4. Rotate the key switch to the O
FF
position, and then connect the main wire harness P23 connector at the EZ-Turn
proximity sensor.
26