14 - EN
TAR1 400V / 230V
3
Product description
Control elements
1
2
3
5
4
6
1 LED display
4 Housing cover
2 Extend support button
5 Main switch
3 RETURN loading bridge
button
6 HEBEN loading bridge
button
Programming control elements
3
4
1
2
5
1 LED display
3 Up navigation button
2 LED spot (confirmation of
the programming entry)
4 Down navigation button
5 Programming button
(Prog button)
Rating plate
The rating plate is located at the side on the control housing. Ob-
serve the power supply specifications.
Made in Germany
W
N
X
X
X
X
X
X
X
X
/X
X
7
1
2
3
4
5
6
1 Control type
5 Max. motor power
2 Manufacturer and address
6 Protection type
3 Supply voltage
7 WN number
4 Amperage
Technical data
Height x width x depth
250 mm x 215 mm x 120 mm
Assembled vertically
Cable feed-throughs
6 (4) x M20
2 x M16
2 x M20 V cutout
Supply voltage
3N~ 400 V
3~ 230 V
Control voltage
24 V DC
Max. motor power
1.5 kW
Protection type
IP 54 (IP 65 optional)
Operating temperature
-20 °C
+50 °C
Manufacturer
Novoferm tormatic GmbH
Eisenhüttenweg 6
D-44145 Dortmund
www.tormatic.de
4
Installation
DANGER
Hazardous voltage
The product runs on high voltage Before starting
with the installation,observe the following:
•
Have all work on electrical connections car-
ried out by a skilled electrician.
•
The power connection must be executed in
compliance with the mains voltage avail-
able.
Follow the instructions as well as the illustrations in the
"Connection diagrams" chapter.
1.
Tools required
For the assembly of the control, you require the following tools:
•
wooden folding rule or tape measure
•
cross-tip screwdriver Phillips; size 2
•
drilling machine
•
drill 6 mm
•
Torx screwdriver, size T20
•
slotted screwdriver for electricians
•
spirit level
•
marking pencil
2.
Opening the control cover
Open the housing cover by either loosening the two screws on
the left or right on the cover.
3.
Assembly of the control
Assemble the control as specified on the drilling drawing.
NOTICE
Selection of the place of installation
When selecting the place of installation, observe
the preconditions in compliance with the tech-
nical data.
4.
Terminal designation
J1
External operation
J4
Emergency stop
J5
Door open sensor
J6
Wheel chock
J7
Key switch
