TECHNICAL DOCUMENT
Examine Perpendicularity in the X Direction
1. Verify that the rod is perpendicular to the machine table in the X direction: compare the rod's position to the
vertical edge of the machinist's square.
l
If the rod is perpendicular to the vertical edge of the machinist's square, go to "Examine the
Alignment of the Carousel Door Opening" (below).
l
If the rod must be adjusted, go to Step 2.
2. Loosen the two socket head cap screws on the linear rails.
Figure 10: Socket head cap screws on the linear rails.
3. Slowly pivot the linear rails up or down until the rod is perpendicular to the vertical edge of the machinist's
square.
4. Tighten the socket head cap screws.
5. Reexamine the alignment of the ATC in the X direction. If the rod isn't perpendicular to the vertical edge of
the machinist's square, repeat Steps 2 through 5.
Examine the Alignment of the Carousel Door Opening
1. Remove the tool holder from the fork, and set it aside.
Note:
You'll need this tool later in the installation procedure to make further alignments.
Page 12
©Tormach® 2020
Specifications subject to change without notice.
tormach.com
TD10627: Owner's Guide: 770MX Automatic Tool Changer (ATC) (1220A)
