TECHNICAL DOCUMENT
7. From the
Status
tab, make sure that the
VFD Running
green light comes on.
Figure 16: VFD Running light on the Status tab.
Note:
If the VFD Running light did not come on in the previous step, we can help. Email
to contact Tormach Technical Support for guidance on how to proceed.
8. Select
Stop
.
The spindle stops.
Make Final Alignments to the Automatic Tool Changer (ATC)
Complete the following steps in the order listed:
Adjust the Tool Alignment and Set the Tool Tray Height and Encoder Position
Adjust the Tool Alignment and Set the Tool Tray Height and Encoder Position
1. From the PathPilot interface, on the
ATC
tab, select
Ref Tool Tray
.
Figure 17: Ref Tool Tray button on the ATC tab.
The tool tray spins.
Note:
You're only required to reference the tool tray once, unlike the mill axes’ referencing
procedure.
Page 18
©Tormach® 2020
Specifications subject to change without notice.
tormach.com
TD10627: Owner's Guide: 770MX Automatic Tool Changer (ATC) (1220A)
