5
DZS200
1. DESCRIPTION
1. 2 Channel controller
2. 365 Day holiday scheduling on both channels
3. Astronomic setting on one or both channels
4. Holiday settings — 16 single dates for 8th day
schedules and 5 block holidays of unlimited
duration
5. Signaling — 48 momentary contact signals
per channel, 1-99 seconds duration (user
settable)
6. Manual overrides to the next scheduled event
7. Automatic daylight saving user settable
8. Automatic leap year compensation
9. AM/PM or 24 hour format
10. Battery backup — 72 hours — recharges
automatically
2. INSTALLATION
1. Remove unit from enclosure (see diagram on
page3), push tab to swing unit to left and
remove.
2. Mount the enclosure at eye level using screws
or other suitable fastening device.
3. Controller is set up to dis-
play in AM/PM format. For
24 hour operation, locate
blue jumper on printed cir-
cuit board (there is only one)
and insert it onto both pins.
NOTE:
Jumper is on one pin
only. (See illustration)
4. Connect battery (included) to the unit by gen-
tly pushing it onto mount in back of the unit.
NOTE polarity of snap-in socket.
5. Bring supply and load wires in through bottom
or side knockouts. Be sure the unit is ground-
ed at convenient terminal marked “GND”.
6. Reinstall unit by reversing step 1 above and
connect wires to unit, as per suggested wiring
diagram. See diagram on page 3.
JP4
JP3
10
RP 1
7. POWER-UP CHECK: To make sure display
and microprocessor are functioning properly,
press and hold ENTER button as you insert and
remove pin or fine point ballpoint pen in
“RESET”hole in upper right side of front panel.
All segments of display should come ON — see
illustration below.
Release button and proceed. This completes the
self diagnostics and also clears all memory.
1.0 TO SET TIME AND DAY
Press the RUN/SET key until the TIME/DAY symbol
begins to flash. The display shows
Press ENTER.
The hour digit is flashing. Press ADVANCE to set the
correct hour. (Note AM/PM.) Press ENTER.
The minutes are flashing. Press ADVANCE to set the
minutes, if needed. Press ENTER.
The bar under SU is now flashing. Press the
ADVANCE key to move the bar to the present day of
the week. Press ENTER.
The bar under H1 is now flashing. Press ADVANCE to
pass it.
6
SU MO TU WE TH FR SA H1 H2
AM
PM
HOLIDAY
TIME/DAY
DATE
SCH/RVU
DLT
RVU
SET
★
LATITUDE
SUNSET
SUNRISE
ON
A
SCH.
SIGNAL
OFF
B
SIG. TIMER
SU MO TU WE TH FR SA H1 H2
AM
HOLIDAY
TIME/DAY
DATE
SCH/RVU
SET
LATITUDE
SUNSET
SUNRISE
ON
A
SCH.
SIGNAL
OFF
B
1
SIG. TIMER
