5)
The sun or brightness sensor (available only for TF24, TF24/R, TF24/T and TF44,
TF44/R and TF44/T) enables by means of the “DIP-switch”
No.6
that has to be in
OFF
position;
6)
The brightness (sun) sensor trips any time that the light intensity value exceeds the
programmed threshold and remains at those values for at least 10 consecutive
minutes. The tripping threshold is adjusted by acting on the
Trimmer RT1 (Fig.3)
placed on the electronic card of the control unit. The trimmer adjusts from
0
(darkness) to about
50 klx
(shining sun and clear midday sky) with intermediate
progressive values; (see diagram given here below). The exceeding of the threshold
set on the trimmer generates an OPEN/CLOSE command to the motors connected
to the outputs
M5
and
M6
(motors
No.3
and
No.4
);
Tab.2
Tab.3
Speed
5 km/h - (2,083 Hz)
10 km/h - (4,167 Hz)
15 km/h - (6,250 Hz)
20 km/h - (8,333 Hz)
25 km/h - (10,417 Hz)
30 km/h - (12,500 Hz)
35 km/h - (14,583 Hz)
40 km/h - (16,667 Hz)
DIP-switch
N.1 N.2 N.3
OFF
OFF
OFF
OFF
OFF
ON
ON
OFF
OFF
ON
OFF
ON
OFF
ON
OFF
OFF
ON
ON
ON
ON
OFF
ON
ON
ON
OFF
ON
14
TF21/44R/T
Fig.3
INSTALLATION AND USE INSTRUCTIONS
5- INSTALLATION
Function
DIP-Sw. No.6
Brightness sensor enabled (wind/rain sensors outputs M5-M6 disabled)
Brightness sensor disabled (wind/rain sensors outputs M5-M6 enabled)
klx
VER.1.0
REV.07.04
