To enable a remote control proceed as follows:
• Press
SP2
until the RED LED
DL2
lights.
Then release it.
• Press any key of the remote control that you wish to enable.
When the receiver receives the signal from the remote control, the LED
DL2
switches
off.
• Press again, a second time, the key of the remote control.
The LED
DL2
blinks for a while to indicate that the remote control has been
programmed.
• Repeat the steps described above for each remote control that you wish to enable.
THE PROGRAMMING PHASE ENDS, IF THE RECEIVER DOES NOT RECEIVE ANY VALID
CODE WITHIN 30 SECONDS.
THE RECEIVER CAN STORE UP TO 6 REMOTE CONTROLS. AN EVENTUAL SEVENTH
REMOTE CONTROL WILL NOT BE ACCEPTED.
DURING THE PROGRAMMING PHASE, MOVE THE REMOTE CONTROL AWAY FROM THE
RECEIVER OF AT LEAST 1.5 METERS.
5.7.1- PROGRAMMING RESET
Should you wish to delete all programmed remote controls, press the key
SP2
on the
electronic card of the control unit until the LED
DL2
, which has in the meanwhile
switched on, does not start to blink. At this point, all remote controls previously stored in
the receivers have been deleted. The deletion lasts about 8 seconds.
17
TF21/44R/T
INSTALLATION AND USE INSTRUCTIONS
INSTALLATION -5
VER.1.0
REV.07.04
