11
INSTALLATION -5
5.1-
5.2-
GENERAL INSTRUCTIONS
THE DEVICE INSTALLATION CAN BE PERFORMED EXCLUSIVELY BY COMPETENT AND
QUALIFIED TECHNICAL PERSONNEL SATISFYING THE PROFESSIONAL AND
TECHNICAL REQUIREMENTS FORESEEN BY THE LAWS IN FORCE IN THE COUNTRY OF
INSTALLATION.
BEFORE CONNECTING THE MOTORS (ACTUATORS) TO THE FEEDING AND CONTROL
UNIT, VERIFY THAT THEY ARE CORRECTLY INSTALLED ON THE FRAMES IN
COMPLIANCE WITH THE RELATED "INSTALLATION AND USE INSTRUCTIONS".
THE DEVICE HAS TO BE PLACED WITHIN THE ROOM IN A SUITABLE POSITION
ACCORDING TO THE DISTANCE OF THE MOTORS (ACTUATORS) TO BE CONTROLLED
IN COMPLIANCE WITH THE SAFETY CONDITIONS FORESEEN BY THE LAWS IN FORCE
IN THE COUNTRY OF USE.
THE FOLLOWING INSTRUCTIONS, TO EASE UNDERSTANDING, REFER TO A FEEDING
AND CONTROL UNIT CALLED TF2 FOR FOUR MOTORS, SINCE THE ONE FOR ONE
SINGLE MOTOR HAS A SIMILAR OPERATION.
INSTALLATION OF THE SENSORS
THE INSTALLATION OF THE SENSORS FOR WIND, RAIN, SNOW, ETC. HAS TO BE
PERFORMED OUTSIDE THE BUILDING, PREFERABLY ON THE ROOF OR IN A SIMILAR
POSITION.
1)
The
rain sensor
has to be placed with an inclination of 5°÷10° with reference to the
horizon and in such a position as not to have shields against rain fall (the positioning
under trees or close to walls shall be avoided since this alters the natural
meteorological event);
2)
The
wind sensor
shall be located far from hindrances, which influence the wind flow
(gutters, trees, walls, etc.);
3)
The
brightness sensor (sun)
has to be placed in such a position as to assure the
same intensity of light perceived on the windows on which are installed the motors
(actuators) fed and controlled by the feeding unit.
TF21/44R/T
INSTALLATION AND USE INSTRUCTIONS
VER.1.0
REV.07.04
