TOPEX MobiLink
IP
Preliminary Manual
-
mark the position of a pair of holes on the wall,
spaced at 55 mm apart
-
drill the holes in the wall
-
insert the plastic dowels into the holes
-
thread the metallic woodscrews into the plastic
dowels leaving the end to protrude outside for
some 5 mm
-
hang the case of the MobiLinkIP in the two
metallic woodscrews and push it down a little to
get it fixed
-
if it does not lock properly, adjust the screws
Figure 1. Mounting MobiLinkIP on a wall
No matter if it is installed horizontally or vertically, the best location for MobiLinkIP is in the middle of
the location where wireless coverage is needed.
Installing MobiLinkIP on a shelf higher up, with no obstructions around, ensures the best performance
embedded GSM or 3G modems.
Take care to ensure adequate cooling of the MobiLinkIP terminal.
IDENTIFICATION OF CONNECTORS
Topex MobiLinkIP features only two external connectors, as described below. On the bottom panel of
the equipment they are, from left to right:
Figure 2: Connectors of MobiLinkIP
Towards the left edge, the round connector is for the power supply jack, (labelled
DC)
(12V
DC
)
The black Reset button, recessed (
labelled RST
)
To the right, one female RJ45 connector for the local network connections
(labelled ETH
CONNECTING THE DATA CABLES
To ensure the proper functioning of the Topex MobiLinkIP unit, make the right cable connections, as
described below.
TOPEX S.A. +4 021.408.39.00
Page 17 of 80
